Inconsistant PMR

[imaginer123]

IDK what could have been the problem at the chrono with the PMR. I had semi good paint, dwell is at 25, good paint/barrel match, lubed bolt and reg nd new battery. I lubed the bolt with slick honey and reg with dow 33. It was quite cold (around 30) where I was playing but I was wondering would that cause horriable fluxiations within velocity? I have a feeling slick honey was the problem.

I know it wasnt the cold because after I warmed up my gun and shot it in my backyard I saw the balls flying all over.

BTW would dm5 detents with the springs non cut cause this problem? having too much spring tension on the actual detent? I replaced with dm4 rubber nubs and I had relubed with hater sauce v2 incase the slick honey was the cluprit. I tried after practice in my backyard and it seemed to be better. Am I missing anything to make it more consistant?

Heres a few of my like-readings
270, 310, 327, 306, 280 ect ect

[Hawk]

Hmmm....
Well, First off, why did you relube the reg? The dye slick lube on there is actually great stuff for the reg. Smooth, consistant, and can take a lot of punishment for a long time.
Most people that relube their regs generally report back that they have HORRIBLE consistancy at the chrony.
Generally because they used Far too much, but also depends on the lube as well.
My first advise is to take the reg apart again, and wipe it completely clean. Then, use the Dye lube and lightly coat everything so that it just barely looks wet. That's it. Reassemble and air it up and leave it aired for an hour or so. Then degass, air up, and go test.

[imaginer123]

Well I bought the gun used and he didnt have a reg so I am using my reg off my backup matrix. I know I didnt overlube it, I put just a little bit to make the o-rings wet. I replaced the bolt tip o-ring just a little bit ago hoping that was it. BTW I dont have dye slick lube, I bought the gun used.