FF bolt and other bolt mods?

[cdwise86]

i was wondering what other mods work with the freeflow bolt? kapp bio sleeve, kapp top hat, and leethal mod mainly.. orracle spacer? i dont think any of these should cause problems with it, but i wanted to hear from the boys at pro paintball just to make sure...

[overcast]

We are in the process of testing all of these together. Stay tuned.

[cdwise86]

will do.

[Phil]

http://www.pbnation.com/showthread.php?s=&threadid=250690

He wasn't using the KAPP stuff you mentioned though

[doby45]

Well I have found form my trials that you can NOT use the KAPP Bio Sleeve with the FF Bolt simply because there is not an o-ring that will seal the sleeve. I went thru about 8 o-rings in my set and lost about 1500psi form my tank trying to seal that bastard. I now have my Evolve beercan/front wall in and have no more air for testing, but I will say it sure does slide easy. :P

[sh0rt]

my bolt sealed in the BioSleeve...with the second o ring i tried...

i will get 2 more kits then i will make a field trial,,,on saturday--

[cdwise86]

what about the top hat? i hope it all works, cause i have one of each mod for both of my trixes... leethal mod tested yet?

[Hawk]

Doby, Somewhere in here either Ethan or the guy from Kapp said that you will need to use the #15 o-ring with the bio-sleeve.

[krazi_ivan]

We include two #14 o-rings. Your need a #15 to work with the Bio Sleeve. You get a number 15 with the bio sleeve.

-E

Da, he did. I could have sworn I tried the O-ring that came with it,
mine leaked like hell as well. I may try it again on my second Matrix,
but I wont sweat it if it don't work. 8)

[weidjd]

Seen as stupid ? so I delete it for ya.

[Buckeye Matrix]

Call them up or pm ethan and go from there. I have a little hint for all out there that ask this type of question, (which is normal by the way,) why ask second and third parties on how to do things? Call the frikken experts and get the lowdown. You usually will have to do that anyway. This is a good guage of their service. There are only 3-5 people out of 1800 on this forum that I KNOW they KNOW what to do and how to do it. Call up FF and they will tell you how to do it. Peace.

[chrisfx811]

when i placed my ff bolt in my kapp biosleeve it had a large gap in there. unfortunately i cannot locate my #15 o-ring that came with the biosleeve, so i put in my 1pc evolve beercan/front wall.
hopefully tomorrow i will have numbers to contribute to the thread concerning efficiency.
now i have an awful lot of spare bolt parts :shock:

[cdwise86]

tell me about it- if i had an extra front wall, i would have an entire bolt.

[cdwise86]

ok i finally got the KAPP top hat to seal. just had to use the right 0-ring. went through about 3 # 15's, but the last one i used worked =)