Help Tuning

[Dye_Pb_Master]

Im not sure how to tune on pbnation.com flesheater said to drop lpr to 0 then back out until bolt it cycling fully and fast (wich i couldnt really find its hard, trying to know if its going full speed) then drop dwell and up untill you see velocity change then down 2. Is this right? Also macky can i talk to you on aim? I dont understand when he says pick a dwell cause how would i go about trying to get the lowest dwell possibly?

[bmxer22225]

look at the sticky on tuning ur lpr in the air forum

http://forums.matrixowner.com/showthread.php?t=8505
hope this helps

[EnigmaX]

I would also be interested in some good information on this subject. The stock settings work fine for out of the box, but once everything is broken in, I'm sure it can be tuned a little :-D

[Macky]

As for "pick a dwell", its easy stock is 18 if you want to use a lower dwell then use a lower dwell and if you want to use a higher dwell then use it.

There will be a point were the dwell can be too low and the PM6 will not operate.
Try some different dwells I was surprised when my PM6 operated at a dwell of 10 with the stock bolt.

[Dye_Pb_Master]

Hey macky i want to talk to ya on aim your away right now though. But a dwell of 15 would be better than 18 right? When you say pick a dwell can we just start from the bottom and up it until we see the velocity fluceute(sp) then decrease it two? Then set lpr? Why does pbnation say to do it different?

[Macky]

Cause PBN is a copy straight from the user manual. Through the Last 6 years we have learn if you keep the dwell the same and adjust the regs to match then you get the best performance.

A DM4/5/6/C or Proto operates the same as a Old school matrix with a SCM LPR or dye mini rocket cause those LPR's are self compensating. The LPR in the DM4/5/6/C and proto's are also self compensating. So Set up is exactly the same